Spider mites damaging some soybean

Twospotted spider mites are serious pests whenever hot, dry weather persists. Large spider mite populations may develop on both soybean and corn. Injury to soybean has been seen near Atlantic in southwestern Iowa. No injury has been reported in corn.

Although many species of mites can injure plants, it is the twospotted spider mite that attacks soybean and is the primary mite on corn in Iowa. These mites are mostly greenish white to yellow. The twospotted spider mite is named for the two dark spots, which are digested food, visible through the sides of the abdomen of adult females.

Spider mite injury to soybean can superficially resemble herbicide injury or a foliar disease; however, characteristic signs are tiny yellow spots, or stipples, on leaves. As the injury becomes more severe, leaves turn yellow then brown or bronze, and finally die and drop off. Soybean plants injured by mites mature early, have increased shattering, produce smaller seeds, and may produce wrinkled seeds. Early and severe mite injury left untreated can eliminate yields. More typical mite injury, occurring during late vegetative and early reproductive growth, reduces soybean yields 40-60 percent. Spider mites can cause yield reductions as long as green pods are present. Soybean plants can recover from substantial amounts of mite injury after treatment, although less compensation is possible in later developmental stages.

Spider mite injury (foreground) to soybean near Atlantic, Iowa.

Severe spider mite injury can cause leaf death in soybean.

Spider mite injury can be spotty, ranging from severe on the edge of the field to being unnoticeable in another section of the same field.

Before treating, check that living mites are present. Examine all areas of the field, especially downwind, to identify the extent of the infestation in apparently healthy plants. Because they are small and stay on the undersides of leaves, spider mites can be difficult to see. One way to spot them is to slap leaves against a white piece of paper (a paper plate works nicely) and look for very small moving dots on the paper. A hand lens is useful to distinguish spider mites from thrips, which are noticeably elongated insects that move more rapidly than spider mites. Thrips are another sap feeder that are not uncommon but rarely, if ever, cause economic damage to soybean in Iowa.

When normal weather patterns with locally dry conditions occur, treatment is recommended when plants in infested areas have substantial stippling or leaf yellowing and live mites. Treatment may be delayed if cooler temperatures and high humidity are expected; however, scattered thunderstorms and rain alone cannot reduce mite infestations. Closely monitor infested fields if treatments are delayed, and treat before mites cause browning and leaf drop. Spot treat if the infestation is localized, but check other areas for mites.

Under drought conditions, treatment is recommended if leaves in infested areas are stippled and live mites are present. Before treating, check the entire field (and adjacent fields) for mites. Under very dry conditions, mites usually will occur throughout the field and spot treatments are unlikely to prevent the infestation from spreading. If mites are found throughout the field (even in low numbers) in addition to the more heavily infested areas, treat the entire field. Closely monitor treated fields for reinfestations. Avoid unnecessary sprays, but treat before injury becomes severe and leaves drop.

Late infestations can be difficult to control because mites accelerate soybean maturity and increase shattering. Consequently, if infested fields still have green pods but seeds are filling, it may be better to accept some yield loss from mites and not treat rather than treat and have shattering but be unable to harvest. Carefully check for harvest intervals on insecticides used if treatment is warranted. Scouting for mites earlier in the season helps avoid any problems with harvest intervals.

Insecticides labeled for mites in soybeans are Lorsban and dimethoate. Read and follow all label directions.

This article originally appeared on pages 148-149 of the IC-488(18) -- July 22, 2002 issue.

Updated 07/21/2002 - 1:00pm