Gypsum is calcium sulfate (CaSO4). Refined gypsum in the anhydrite form (no water) is 29.4 percent calcium (Ca) and 23.5 percent sulfur (S). Usually, gypsum has water associated in the molecular structure (CaSO4·2H2O) and is approximately 23.3 percent Ca and 18.5 percent S (plaster of paris). Gypsum fertilizer usually has other impurities so grades are approximately 22 percent Ca and 17 percent S. Gypsum is sparingly soluble (the reason wallboard gets soft but does not immediately dissolve when it gets wet, at least if only damp occasionally). Gypsum is the neutral salt of a strong acid and strong base and does not increase or decrease acidity. Dissolving gypsum in water or soil results in the following reaction: CaSO4·2H2O = Ca2+ + SO42- + 2H2O. It adds calcium ions (Ca2+) and sulfate ions (SO42-), but does not add or take away hydrogen ions (H+). Therefore, it does not act as a liming or acidifying material. The Ca2+ ions simply interact with exchange sites in soil and sulfate remains dissolved in soil water.
Gypsum as a fertilizer?
Gypsum is a fertilizer product and supplies the crop-available form of calcium (Ca2+) and sulfur (SO42-). If these forms are deficient in soil, then crop productivity will benefit if gypsum is applied. This is a big "if" for Iowa soils. Research has not shown deficiency of Ca and normally any potential problem with low Ca levels is taken care of with application of limestone (CaCO3). Acidity problems will occur before a deficiency of Ca, so liming effectively takes care of Ca also. Table 1 lists typical exchangeable Ca levels of several Iowa soils, and they are very high. For calcareous soils (containing free lime) the soil system is saturated with Ca, and Ca supply and soil pH is controlled by the free lime.
For S, it's basically the same. Research conducted for more than 35 years in numerous field trials across Iowa has shown only isolated and very small corn or soybean yield response to S fertilization (two positive and one negative). Table 2 gives results for recent S trials on corn and soybean conducted in 2000 and 2001 at six sites across Iowa. These results are typical of research conducted for many years in that there was no yield increase to applied S, gypsum, or Ca. So, if there is no need for fertilizer application of Ca or S, then gypsum application is simply not needed for fertilization reasons.
Gypsum as a soil amendment
Soil structure is impacted by exchangeable cations (positively charged ions). Multivalent cations (more than one positive charge) help hold soil particles together because they can have electrostatic (magnetic) attraction between two or more negative charge sites (soil clay and organic matter have a net negative charge). Multivalent cations include Ca2+, Mg2+, Zn2+, and Al3+. Monovalent cations (only one positive charge) cannot help with soil structure because of only one positive charge, and with sodium (Na+), for example, can degrade soil structure when large amounts occupy the soil exchange sites (also impacted by large ionic size of Na); thus, soils with low salt but high levels of exchangeable sodium (Na+) have poor soil structure. Except for a very small acreage of Napa soil in the Missouri River valley, excess Na is not a problem on Iowa soils, including those with high pH. In arid regions where salt and Na accumulates (saline-sodic soils), reclamation can include use of gypsum. Gypsum is used to add large amounts Ca2+ ions that displace the Na+ ions from the exchange sites, and when flushed with clean water both salts and Na are removed from the soil (gypsum is used instead of limestone because of higher solubility and no increase in soil pH). However, even in these sites this practice is not effective when subsoils have low permeability to water. If a soil only has high soluble salt, then gypsum is not used because it would add to the salt problem.
Soil structure also is greatly improved by soil organic material, which help "glue" soil particles together. Iowa soils have high organic matter content, which is just as important for good soil structure as exchangeable multivalent cations. The most detrimental effect on surface soil structure comes from the physical impact of raindrops. Surface residue is the best defense against this impact, and it comes at no cost from crop residue. Thus, improving water infiltration can be best achieved by limiting tillage to leave the most crop residue as possible rather than applying gypsum. Table 2 shows the lack of corn and soybean yield response to applied gypsum.
In summary, gypsum is an excellent fertilizer source of Ca and S. If application of these plant-essential nutrients is needed, then it works well. However, for Iowa soils both Ca or S are in good supply. Iowa soils inherently have a capacity for providing adequate levels of exchangeable Ca and S for crop production. Thus, more is not necessarily better.
Table 1. Exchangeable calcium and magnesium of several Iowa soils.
CEC in the table above is cation exchange capacity.
Table 2. Corn and soybean yield response to gypsum and elemental S application, average across six sites in Iowa.
|lb S/acre||lb/acre||lb Ca/acre||bu/acre||bu/acre|
CaSO4, calcium sulfate (gypsum); S, elemental sulfur (90% S); applied before planting in the spring of 2000.
J.E. Sawyer and D.W. Barker, Department of Agronomy, Iowa State University.
This article originally appeared on pages 46-47 of the IC-490 (5) -- April 21, 2003 issue.